Pretty simple job involves editing my current leg textures.
Not asking for any creativity/artistic ability just good GIMP/PS editing.


To simply put i want 3 textures:
512 Left Thigh
128 Left Knee
512 Left Shin

And using the attached images i want my skeleton snake to spiral down and around my left leg in a single helix pattern.

The snake should wrap around as many times as possible without looking cramped.

The head should should place at the top center of the left thigh, facing inside.

The tail should place at the bottom center of the left shin, pointing straight down to the foot.

This is my leg currently:
SEE POST #4

Nobody thinks they can do this?

How much TC would you request to do this edit?

OKAY. Current offer is 10k.

I have drawn out the basic path of the leg textures.




This will hopefully make the job easier. I need somebody to breakdown the jpg/gif images i have attached in this post (#4) and edit them so they follow the pre-drawn path.

Stipulations
1. The head of the snake will be placed at the top of the thigh. Facing inside towards the other leg.
The top of the head will not go any higher than the predrawn path. (The top of the path is the height limit, do not center the on this end point).

2. The neck and body will spiral around the thigh as shown. This should look organic with one or two small curves as it follows the path.

3. The knee is tricky. The transition to the knee texture should look as seamless as possible.
You'll see on the rear of the knee texture the path peaks out under the thigh. This is to compensate for when the knee contracts, and the top of the texture will be exposed.
The artist should assume the knee to always be fully extended or fully contracted. Don't worry about in between, and dont worry about the small gap when the knee is contracted.

4. Similar to the tigh, the snake will transfer seamlessly from the knee to the thigh. Then it will again start to spiral around the back of shin.

5. The point where the path stops and goes straight down to the ankle is where the tail of the snake will begin. This texture will transfer seamlessly on the ankle joint and come to end point at the bottom pole of the ankle.

6. This must be a shaman colored snake on a black background. However the knee and ankle textures should be white because my shaman force will give the appearance of cobra.
-----
If you need my current leg textures with the predrawn paths:

./dl aquita

open the customs folder and find my name. they will be in there.